"Returned to complete the repair on the unit after initial diagnosis. The required part, drain pump, was installed successfully. After installation, I tested the unit and confirmed that it is now operating as expected. This repair resolves the previously identified issue: Dr error code."

"Returned to complete the repair on the unit after initial diagnosis. The required parts, knobs , were installed successfully. After installation, I tested the unit and confirmed that it is now operating as expected. This repair resolves the previously identified issue: broken knobs."

"Returned to complete the repair on the unit after initial diagnosis. The required part, freezer door rails, were installed successfully. After installation, I tested the unit and confirmed that it is now operating as expected. This repair resolves the previously identified issue: Freezer melting."

"Performed diagnostic on the unit. The customer reported that the microwave has no power. Upon inspection, I found that the fuse was blown. The issue is caused by wear and tear. In order to resolve the problem, the following repair was conducted: Replaced fuse."

"Performed diagnostic on the unit. The customer reported that refrigerator leaking under bottom shelf. Upon inspection, I found that the fresh food defrost system was not operating correctly and frosting over back panel. Pulled unit and tested defrost system from board after unplugging, upon plugging back in power module was blown out likely due to prior burning out. The issue is caused by lack of airflow to unit and wear and tear. In order to resolve the problem, the following repair is needed: Replace fresh food defrost heater, panel, and power module. The total cost for the repair will be discussed at a later time from the office."