"Performed diagnostic on the unit. The customer reported that oven not heating. Upon inspection, I performed resistance test on igniter. The results showed that igniter open. The issue occurred due to wear and tear. In order to resolve the problem, the following repair is needed: replace igniter. The customer approved the repair during this visit, and the required parts were installed successfully. After installation, I performed functional testing to confirm the repair. The unit is now operating as designed. This repair resolves the previously identified issue.; used 1 IG9998 (SPARK MODULE / IGNITER) from stock"

No mechanical failure at time of appointment. Unit operational. Service call $109 covering any failures for 2 weeks .

"Performed diagnostic on the unit. The customer reported that washer not finishing spin. Upon inspection, I found that control and water level switch faulty. The issue is caused by wear and tear. In order to resolve the problem, the following repair is needed: replace control and water level switch.